Bonus Infladores

Very useful accessory when fixing any decoration, balloons, garlands, TDB panels, columns, in hard-to-reach points or not.

HOW TO USE

- Always be careful when removing the protection (green tape), so that you do not touch the adhesive with your hand.
- If possible, always clean the place where it will be applied well. Use a dry cloth to remove all dust particles that prevent the fixture from having a 100% perfect adhesion.
- Be careful when using it on glass, as it usually has grease particles that prevent perfect adhesion.
- Preferably, wait a few minutes before hanging or placing the decoration, as this will make the adhesion even more effective.
- In Alturas, for example, just have an aluminum tube where you can place the rounded part (where you tie the decoration) inside and raise the stick without the adhesive in the desired place. Ready, the decoration is fixed, without the aid of stairs.
- To release the balloon fixer, just twist the adhesive to the sides, by 180 degrees, or, if you have it within reach, heat it up a little with a hair dryer or even with the heat of the balloon inflator.