mechatronics.by

The precise knowledge of the fuel amount in the tank helps to optimize the time and place of fillings, as well as to prevent fuel thefts. Fuel level control in the tank of vehicles and aggregates is the most affordable and economical solution of fuel control in modern GPS tracking systems.
Fuel level sensors Eurosens Dominator provides an accurate measurement of fuel and transmit the information to the terminals or transport monitoring gauges by various interfaces.

High-precision measurement
Output interfaces RS-232 & RS-485, voltage, frequency, CAN bus
Built-in temperature compensation
Modular design
Strong electronic circuit protection
Sealed automobile connector on sensor body
Efficient packaging, installation and sealing
Dominator fuel level sensors are designed to minimize the operating costs of fuel consumption monitoring system for the entire period of its operation.

Powerful electronic module protection. External power voltage protection up to 170 volts.
The modular design allows not only cut the sensor for a specific vessel, but also to extend the electrode. This is useful when you reinstall the system to another object. Sensors of traditional non-modular design can’t be extended and once shortened electrodes can’t be replaced.
Easy sealing of the sensor from disconnection cable and sensor removal.
The electrodes can be easily disassembled and cleaned. Sensors of conventional design can be contaminated in the gap between electrodes that require a complex maintenance. Dominator electrodes can be cleaned by the customer without warranty violations.
The modular design makes it easy to provide technical support of installed sensors. We can easily localize the problem either in the sensor “head” or in sensor electrodes, because electrodes can be disconnected from sensor “head”.
If the fault is in the “head” of the sensor – replacement can be done even by the end user – the owner of the equipment. Thanks to bayonette, a fast-lock replacement is very easy and takes about 10 minutes. It is much cheaper than travel costs of installation staff.
After sensor “head” replacement, you don’t need to make a tank calibration again (unlike traditional design sensors).
Warranty term – 5 years.



During the development of the fuel level sensor Dominator, we set ourselves the task to provide a new level of capabilities. Many well-known fuel level sensors have approximately the same accuracy of measurement, the possible improvements are possible in terms of improving the reliability and stability of measurement, ease of installation and service. The cost to replace the fuel level sensor (including the costs of travelling) often exceeds the cost of the fuel level sensor. We have tried to design Dominator level sensor so that the cost of maintenance over the whole life of the fuel monitoring system was minimal.
We did not save on the thickness of the wires, the quality of plastic, electronic circuit protection, stylish design. We save on another thing - the fuel level sensor Dominator is cheaper during operation and service.