Zametal

Mat with top and bottom lighting for final product selection.
Structure - Made entirely of stainless steel AISI 304, being the entire side structure and legs in tubes of 40x40mm with feet with height adjustment.
Drive – the gear engine is sew or geremia brand, being the direct transmission on the shaft and the whole system protected by stainless steel covers no. 18.
Headboards – are manufactured in 40x40 tubes with plate reinforcement, passing shaft to support the motor wheels and moved.
Treadmill – is modular model E17C without pigmentation (transparent) of the brand Unirons supported on HDPE profiles.
Lighting - the top and bottom lighting will be done by shielded LED luminaires.
There will be 02 sets at the top and 06 sets at the bottom.
Finishing - the finish is sanitary, all welds being ground and the corners rounded, later sandblasted with micro glass spheres.
Control panel – Installed in an AISI 304 stainless steel case, a frequency inverter is installed internally and externally a button on/off, reset and an emergency button at each end of the equipment. 24V command.
Dimensions – 3,400mm long (usable inspection area 2,580mm) x 900mm wide x 1,090mm high.

WARNING: The standard electrical connection is 380 V. three-phase, if the required voltage is other, please communicate in writing.

Tax classification (NCM): 8428.39.90.
Zametal Code: 05.030.090.01187.

NOTE: WE ALSO WORK WITH MODULAR MAT MODELS, TAPE, TAILOR-MADE.