SuKo Polymer Machine Tech Co., Ltd.

1. PTFE complete set of equipment manufacturers - rod pusher line: rod extruder, mold design, heating ring, automatic feeding one-stop service

2. PLC intelligent control: continuous extrusion, self-sintering, self-adjusting concentricity, automatic feeding

3. Extrusion rod quality: smooth surface like mirror, high tensile strength, high tensile strength, high density.

4. Professional technical guidance: installation and commissioning, operation and operation, process setting, maintenance, after-sales service, raw material channels

First, the equipment operating environment requirements
1. The site floor is required to be flat, and the site load is not less than the design regulations.

2. The operation platform needs clean space to reduce dust ingress, and it is best to have ventilation ducts in the workshop to facilitate ventilation and heat dissipation.

3. Industrial electricity standard 380V 50Hz 3P, voltage can be customized according to user needs.

4. Space configuration distribution cabinet, compressed air and other supporting equipment.

5. The equipment needs to be equipped with a cooling water system, and two barrels/water tanks can be used with cooling pumps to recycle water resources.

6. The room temperature of the plant is recommended to be not higher than 28 °C.

7. Longitudinal vertical extrusion equipment is extruded from top to bottom, and the equipment is installed on the platform or floor, with a space height of about 2.8 meters.

It is necessary to consider the effective distance of the longitudinal direction of the equipment, and ensure sufficient height under the round hole fixed by the equipment to meet the requirements of the length of the extruded tetrafluoro rod.

8. Horizontal horizontal extrusion equipment single-layer transverse extrusion, need to consider the effective distance of the equipment transverse, need to ensure the length of the tetrafluorine rod requirements. The length of the equipment including mold is 4-7 meters (excluding the length of the extruded finished rod), the width is 1.2 meters, the height is 1.8 meters, and the space height is about 2.8 meters.

Through continuous improvement, make the equipment smarter, more stable and more efficient.
The equipment adopts PLC system control, automatic operation, simple operation.
The equipment design is diverse, can meet the different needs of users, customized for customers.
The equipment has a long operating time and low noise. And reduce costs by saving electricity and energy during stress maintenance.
The equipment and molds are manufactured by special process, which is corrosion-resistant, durable and has a long service life.
The device has a simple design and takes up little space.
Extruded products have superior performance in terms of density and tensile strength.
Equipped with automatic feeding system, filled with 50-80 kg of barrels, automatic feeding system can ensure 4-8 hours of operation, greatly saving labor costs.
The PTFE screw extruder can push the rod continuously, and the bar can be cut off according to the requirements.
Provide complete mold system, including a full set of corresponding accessories, heating sintering system, cooling system, thermostat, bracket, etc.
The vertical bar extruder extrudes from top to bottom. The device can be placed on the second floor or on the platform.