Taizhou Shunke Moulding Co., Ltd

1.Stable performance with advanced PLC and conveying preforms automatically with conveyor

2. Strong penetrability and good and swift distribution of the heat by letting the bottles rotate by itself and revolute in the rails simultaneously in the infrared preheater.

3. High adjustability to enable the preheater to preheat preforms in shapes by adjusting the light tube and the length of the reflecting board in the preheating area and eternal temperature in the preheater with an automatic thermostatic apparatus.

4. High safeties with security automatic-locking apparatus in each mechanical action,which will make the procedures turn into a state of safety in case of a breakdown in certain procedure.

5. No contamination and low noise with the air cylinder to drive the action instead of the oil pump.

6. Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.

7. Strong clamping force with high pressure and double crank links to lock the mold.

8. Two ways of operating: Automatic and manual.

9. Safe,reliable and unique design of the position of valve to make the air pressure diagram of the machine easier to understand.

10. Low cost,high efficiency,easy operation,easy maintenance,etc.

11. Contamination is avoided for the bottle body.

12. Ideal effect of the chilling with the chilling system for the bottle mould.

13. Easy installation and starting.

14. Low rejection rate:less than 0.2 percent.

15. Full automatic machine, one man is enough for operation the machine.

16. Adopt the new type double bend arm and the four rod-clamping structure(won the patent): Cross direction; Middle mould board is move parallel; the distance between two mold board is adjusted by the chain wheel. Thus, the clamping force is very strong.

17. Power saving design that can increase your profits.

18. Separated type air controlling system, which is designed for avoiding waste pollution.

19. The preheater of PP blow machine should be more bigger than PET blow machine.